 | | Re: Increase touch sensor sensitivity?
|
|
(...) No, they are essentially switches that are either on or off. Though the whole truth is that they are made from conductive rubber, and that they go from off to on over a very small distance. I once measured this by an arrangement that very (...) (24 years ago, 7-May-03, to lugnet.robotics)
|
| |
 | | Re: TIME STAMP for a LNP distributed robot
|
|
BTW, make sure you include: #include <time.h> Otherwise, get_system_up_time() will only return 16 bits! Mark (24 years ago, 7-May-03, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: TIME STAMP for a LNP distributed robot
|
|
Hi, The sys_time variable is the basic timekeeper for BrickOS. It is a 32-bit integer that is incremented every millisecond by the kernel. In older versions of the kernel you could access the variable directly, however, in 0.2.6.10 and later you (...) (24 years ago, 7-May-03, to lugnet.robotics.rcx.legos)
|
| |
 | | Dr. Vegetable's Virtual Remote
|
|
I have just released a freeware utility program for Windows that emulates the MindStorms infrared remote control using a USB or RS-232 IR tower. The program supports all functions of the remote and does not require any other support software to be (...) (24 years ago, 7-May-03, to lugnet.robotics.rcx) !
|
| |
 | | TIME STAMP for a LNP distributed robot
|
|
Hi, I'd like to make a basic implementation of a time stamp on a distributed schame, using Lamport's algorithm. It states basically that when a node receives a message, it get the time stamp that's contained on it, and compares with it's own, if the (...) (24 years ago, 7-May-03, to lugnet.robotics.rcx.legos)
|