To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3691 (+5)
  Re: Help!! Polaroid problem!!!
 
Generally the capacitor is the problem :-) The capacitor in the original note is there to pull BINH true* to allow the sensor to detect things that are closer than 18". Generally, when you include it, unless the design of the system holding the (...) (29 years ago, 23-Apr-98, to lugnet.robotics.handyboard)
 
  examples
 
I was wondering if anyone out there could send me some very basic, easy to understand programs that could help me figure out how to use sonar modules. Thanks, Richard (29 years ago, 23-Apr-98, to lugnet.robotics.handyboard)
 
  Re: Help!! Polaroid problem!!!
 
Hey, I just wanted to thank everybody for there help with this, it did turn out to be the pull up resistor problem, I feel like a moron. We used the handyboardy sonar interfacing schematic when we wired it up and failed to realize that we aren't (...) (29 years ago, 23-Apr-98, to lugnet.robotics.handyboard)
 
  A Few Questions
 
First I want everyone to know two things. First I am new to this list. Second, I have moderate knowledge of electronics.... Until about a few weeks ago, I had been working with Basic Stamps 1 and 2. After looking at all the information about (...) (29 years ago, 23-Apr-98, to lugnet.robotics.handyboard)
 
  Stepper motor help
 
I am planning on using stepper motors w/ a handy board and will be powering them separately from the rest of the board. What type of motor should I use? I have seen 6 and 12 volt motors availble, if anyone can recommend which to use I would (...) (29 years ago, 23-Apr-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR