 | | Re: Back wheel construction advice
|
|
(...) A better idea yet is to use the pulley wheel without a tire. There is no need for traction in the caster. A hard plastic wheel allows the caster to act like a skid sometimes and minimizes the caster steer experienced when straightening out (...) (24 years ago, 18-Mar-03, to lugnet.robotics)
|
| |
 | | New "Designer Sets" such as 4099?
|
|
Are there any new and robotically-useful pieces in the new "Designer Sets" such as 4099, 4100, 4101, etc? (It's a bit hard to tell from the small photos) (URL) CatID=&OrderBy=0 Thanks Bruce (24 years ago, 18-Mar-03, to lugnet.robotics)
|
| |
 | | Re: How can I reach world related info from Spybotic
|
|
Hello, I have found that source @(0x2d0000) contains the current zone information (nowhere, anywhere, etc) for one spybot/one controller configuration (i have only one spybot). Note that this source continually changes from 0 to the current zone (...) (24 years ago, 18-Mar-03, to lugnet.robotics.spybotics)
|
| |
 | | Re: Back wheel construction advice
|
|
(...) Sure, you can make a caster with the pulley wheel and thin tire though I think it is a little less elegant. For one thing, since the pulley wheel is only 1/2 unit wide, it will slop around unless you use a longer axle and bushings on the ends (...) (24 years ago, 18-Mar-03, to lugnet.robotics)
|
| |
 | | Re: Back wheel construction advice
|
|
(...) tire. You want the wheel to spin on the spot with minimum friction, so wouldn't you want to use a large pulley with a thin tire? ---...--- Steve Baker ---...--- HomeEmail: <sjbaker1@airmail.net> WorkEmail: <sjbaker@link.com> HomePage : (URL) : (...) (24 years ago, 17-Mar-03, to lugnet.robotics)
|