To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3616 (-5)
  re-download problem
 
I forgot to unload the program that I was running on my handyboard before I quit out of ic. and it won't let me putting the board on bootstrap mode. as soon as I power up the board, it starts running the last program. can anyone tell me how to clear (...) (29 years ago, 13-Apr-98, to lugnet.robotics.handyboard)
 
  Servo Routines
 
Question. I've been playin with the servo routines available from the HB page. One thing I've noticed. The servo's seem to chatter a lot. Is this normal. A routine that does nothing but loop, read the knob and output a value based on the knob to the (...) (29 years ago, 13-Apr-98, to lugnet.robotics.handyboard)
 
  Re: Vector V2x Compass
 
Hi Armeen, I have the same problem as you. I thought my HB was faulty or it doesn't work with the 68hc11E processor I use or something. So what I did was: I wrote a very simple IC-Routine. You have to load this program with "load v2x.c" and call the (...) (29 years ago, 13-Apr-98, to lugnet.robotics.handyboard)
 
  Re: 16 digital outputs as Fred suggested
 
1. please read the Appendix B documentation in (URL) explains this in more detail than the FAQ. 2. you must the even-numbered Yx signals for output latches. Since Y6 is taken (by the on-board latch for the motor drivers), you're left with Y0, Y2, (...) (29 years ago, 13-Apr-98, to lugnet.robotics.handyboard)
 
  Re: Help - Cannot download!
 
try using DL.EXE (part of the Interactive C distribution) after following the serial port options directions given the FAQ (under downloading problems). fred In your message you said: (...) (29 years ago, 13-Apr-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR