 | | Vector V2x Compass
|
|
Hello: I have a V2x compass and I was trying to hook it into my handyboard using Tom Brusehaver's .icb, .c and instructions as described in the contributed section. I have also grounded the M/S pin on the compass. The EOC pin is sent to the HB thru (...) (29 years ago, 13-Apr-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Help - Cannot download!
|
|
try using DL.EXE (part of the Interactive C distribution) after following the serial port options directions given the FAQ (under downloading problems). fred In your message you said: (...) (29 years ago, 13-Apr-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: 16 digital outputs as Fred suggested
|
|
1. please read the Appendix B documentation in (URL) explains this in more detail than the FAQ. 2. you must the even-numbered Yx signals for output latches. Since Y6 is taken (by the on-board latch for the motor drivers), you're left with Y0, Y2, (...) (29 years ago, 13-Apr-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Vector V2x Compass
|
|
Hi Armeen, I have the same problem as you. I thought my HB was faulty or it doesn't work with the 68hc11E processor I use or something. So what I did was: I wrote a very simple IC-Routine. You have to load this program with "load v2x.c" and call the (...) (29 years ago, 13-Apr-98, to lugnet.robotics.handyboard)
|
| |
 | | Servo Routines
|
|
Question. I've been playin with the servo routines available from the HB page. One thing I've noticed. The servo's seem to chatter a lot. Is this normal. A routine that does nothing but loop, read the knob and output a value based on the knob to the (...) (29 years ago, 13-Apr-98, to lugnet.robotics.handyboard)
|