To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3581 (+5)
  SPI ram
 
If anyone cares, I have posted my SPI ram card design to the web at (URL) is probably laughable, but I thought it was a good effort for not knowing too much about electronics. Anthony Oren Loeppert *** (URL) * o* * ***> * * * * * | | * * | / * * |/ (...) (29 years ago, 8-Apr-98, to lugnet.robotics.handyboard)
 
  Re: SPI ram
 
Anthony, A easier way to get 8K of EEPROM memory is to use Microchip Technology 25C640 Serial SPI EEPROM Memory. This is a 8 pin DIP device with a built in SPI interface. Cost is about $3 each. I wrote a simple application note to connect to a HB (...) (29 years ago, 8-Apr-98, to lugnet.robotics.handyboard)
 
  Board Simulator
 
Hi All, In the 3.1beta of the Mac version of IC was a board simulator. Is this still supported in the release version for the Mac? Will there be a port to the PC platforms? I find the simulator very helpful in a lot of situations. But since I do my (...) (29 years ago, 8-Apr-98, to lugnet.robotics.handyboard)
 
  LMD18200
 
I just bought the motor driver kit from wirz electronics, and I have finished putting it all together. My question is, do I take the motor drivers off of the HB and put them on the wirz board, or do I leave them on the HB. Question 2: Assuming I (...) (29 years ago, 8-Apr-98, to lugnet.robotics.handyboard)
 
  Re: LMD18200
 
<FontFamily><param>Courier New</param>We've used the Wirz boards with great success here at Washington University. I can answer both of your questions at once, since they're the same thing. YES. Take the drivers off the handyboard, because now the (...) (29 years ago, 8-Apr-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR