To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *35799 (-5)
  Shufflebot Concept
 
Is there any way to make a shuffling (stompbot) drive where three shufflers are used on each side. When one goes up, the other two go down, and when those two go up the other one goes down. This is used to provide locomotion. The best example of (...) (24 years ago, 13-Dec-02, to lugnet.robotics)
 
  RE: Firmware download troubles
 
The size of the firmware isn't going past the 0xcc00 boundary, is it? The firmware in the RCX only does a sum on the bytes up to 0xCBFF in the downloaded firmware, as far as I recall... Cheers, Ralph (24 years ago, 13-Dec-02, to lugnet.robotics.rcx)
 
  Re: BrickOS Threading...
 
Joe, (...) Maybe a special kernel build for testing purposes that increments the lower sys_time word by 0x4000 instead of 1. This will greatly increase the opportunity for this glitch to occur (from once every 65 seconds to once every 4ms.) You (...) (24 years ago, 13-Dec-02, to lugnet.robotics.rcx.legos)
 
  Re: Hammer Help
 
Thanks for the response. I've decided to stay away from string on the robot as string can get easily entangled, especially if battling another robot. I took a break from trying a design using gears and differentials - I was getting really (...) (24 years ago, 13-Dec-02, to lugnet.technic, lugnet.robotics)
 
  Re: Hammer Help
 
In the prototype I used string and winch to set the hammer. I've decided not to use it on the robot - string can too easily get caught and entangled in stuff, especially if it goes up agianst another robot. On the prototype it works surprisingly (...) (24 years ago, 13-Dec-02, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR