To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *35754 (-5)
  RE: Installation Help!
 
Max, Aha! I did that and it got a lot further this time, but still failed. I'll have to wade through the log file to try and pinpoint where it went wrong as I don't want to post the whole 180k. Thanks for your help! Andy -----Original Message----- (...) (24 years ago, 10-Dec-02, to lugnet.robotics.rcx.legos)
 
  Re: Firmware download troubles
 
Matt, I discovered that the IR LED's and detector on my serial tower was located higher than I expected and pointed upward somewhat. I was able to get better transfers when the tower was leaning forward (pointing downward so to speak). Otherwise, I (...) (24 years ago, 9-Dec-02, to lugnet.robotics.rcx)
 
  Re: Firmware download troubles
 
Also: When it seems to get to the very end before the error appears, I sometimes get a long (3-4 seconds) low tone from the RCX. Matt (24 years ago, 9-Dec-02, to lugnet.robotics.rcx)
 
  Firmware download troubles
 
Hi All, I have pulled my RCX out of summer storage and I am trying to bring it to life. I have tried to download the 2.0 Firmware (firm0328.lgo) dozens of times with no success. It starts to download, then somewhere in the middle, or very close to (...) (24 years ago, 9-Dec-02, to lugnet.robotics.rcx)
 
  Re: Installation Help!
 
(...) You need to install the Cygwin gcc package. You need the normal Cygwin gcc to build the Cygwin->H8300 cross-compiler gcc. Max. (24 years ago, 9-Dec-02, to lugnet.robotics.rcx.legos)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR