 | | 2 rcx's
|
|
What would happen if you took a wire from a sensor port on one rcx and connected it to a motor output on another rcx. Would this be a viable way to communicate with 2 rcx's if they could not be position for IR communication? My thought was that you (...) (24 years ago, 28-Sep-02, to lugnet.robotics)
|
| |
 | | Re: Need to compare
|
|
(...) I like the tri-wheel design. If you make if big enough it shouldn't have any trouble. Something like this (or bigger): (URL)For the step, it begins at 1cm and it will be increased until no véhicule is (...) The advantage of an ODEX design. (...) (24 years ago, 28-Sep-02, to lugnet.robotics)
|
| |
 | | Re: Need to compare
|
|
Thanks, Yes, it's the maximum dimensions... We have already seen the shrimp and we think to build something like that (maybe also with tri-star wheels)... But if somebody find a better solution, because we don't know the comportement of the shrimp (...) (24 years ago, 28-Sep-02, to lugnet.robotics)
|
| |
 | | Re: some more questions about lnp.
|
|
The frequency of the RCX's IR does not change at all: " The RCX uses a 38kHz carrier, which is pretty typical for TV remotes. As for the sampling rate, the RCX runs at 2400 bps, which makes each bit approx 417us " (URL) think the only way you could (...) (24 years ago, 28-Sep-02, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: Need to compare
|
|
(...) Is that the *initial* dimensions - or the *maximum* dimensions? If it's just one of those things like "the robot must start off in a box no bigger than 30x60x30" - then it can just fold itself up into that space when they are doing the (...) (24 years ago, 28-Sep-02, to lugnet.robotics)
|
| |
 | | Re: Need to compare
|
|
Thank you for your idea... but I forgot to say you that I have restriction for the dimensions... Dimensions : height : 30cm Lenght : 60cm width : 30cm And we can have 620 Euro's... Bye Vincent ----- Original Message ----- From: "Mike Thorn" (...) (24 years ago, 28-Sep-02, to lugnet.robotics)
|
| |
 | | Re: Need to compare
|
|
Vincent, (...) Without knowing the limitations of your resources, I would vote for a legged vehicle. You can make if large enough that even if a leg did go in the hole it wouldn't fall in or get stuck, you could make it with as many legs as you like (...) (24 years ago, 28-Sep-02, to lugnet.robotics)
|
| |
 | | Need to compare
|
|
Hello everybody, For my university, we must construct a bot with LEGO Mindstorms. This bot has to be able to climb a step, to ride above a (little) whole and to have left and right wheels at different height. In fact, he might be able to go (...) (24 years ago, 28-Sep-02, to lugnet.robotics)
|
| |
 | | Re: some more questions about lnp.
|
|
duh... guess i was kinda wrong here.. IR is in reality a frequency defined from A to B. any messages sent within this spectre is said to be IR messages. so in theory sending an IR message closer to A than B from one RCX. and at the same time sending (...) (24 years ago, 28-Sep-02, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: Watch Dog Timer on the H8 - Working!
|
|
Well, after browsing through the H8 reference another, oh 20 (?), times; and some messing around; it is now working. Basically, I had declared the Control Status Register as an 8 bit value. Since this is a special register (8 bit) that requires a 16 (...) (24 years ago, 28-Sep-02, to lugnet.robotics.rcx)
|