To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *34754 (-5)
  Re: Voltage Sensor
 
Hello again, if you have difficulties making sense out of my previous posting, try viewing it with a fixed-width font. Otherwise all fomulas will ook scrambled. In the Web interface, "view raw message" is likely to work for that purpose, but of (...) (24 years ago, 17-Sep-02, to lugnet.robotics)
 
  Re: Voltage Sensor
 
Hello Tom, (...) Yes. You need a low impedance output driving 0..5V into the RCX, thus overriding its internal pullup. (...) Actually, I should have written "resolution" instead of "accuracy". The 10..15V range spans 5V with 256 steps, giving you a (...) (24 years ago, 17-Sep-02, to lugnet.robotics)
 
  Evansville LEGO Robotics Competition
 
For Immediate Release! Ivy Tech State College and the Evansville chapter 73 of The Society of Manufacturing Engineers announce the Student Robotics Challenge IV titled 'The Eliminator'. This event is similar to our last competition with (...) (24 years ago, 17-Sep-02, to lugnet.robotics.events, lugnet.loc.us.in.eva)  
 
  Re: Picking up CDs.
 
I worked on a similar project about a year ago. I needed to put a small mark on the inside the a CD ring at a certain spot (or pretty near). I had to do this to 4000 CD's. I don't have access to the odd air cylinders, so I had to make do with other (...) (24 years ago, 17-Sep-02, to lugnet.robotics)
 
  Re: Voltage Sensor
 
Caution: the your external supply has one side connected to RCX ground, which is itself connected to sensor input connector right side. Whichever circuit you choose, you will have to make sure that sensor connector will not be reversed (the (...) (24 years ago, 17-Sep-02, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR