 | | Technic Gear Motors. How rugged?
|
|
Our club is about to have some displays that use Gear motors to run it. Members of the club have asked how long a Technic Gear motor run for before it 'breaks down' or has issues. They also have asked if stopping the motors every so often would help (...) (24 years ago, 31-Aug-02, to lugnet.robotics)
|
| |
 | | Re: Help: RCX 1.0 power adapter
|
|
Your comment intrigued me into checking. I grabbed a couple of transformers and checked them (with a 4 1/2 digit true rms meter). Off load (open circuit) one reads 10.4v a/c, the other 10.9v a/c. That is well within Lego's 9 - 12v a/c spec. JB (...) (24 years ago, 31-Aug-02, to lugnet.robotics)
|
| |
 | | Re: Help: RCX 1.0 power adapter
|
|
"John Barnes" <barnes@sensors.com> wrote in message news:H1pMt3.Ao3@lugnet.com... (...) apparent (...) I bet if you put that radio shack supply onto a multimeter you'd notice it went as high as 13 volts... Them multi selectors are not very acurate. (...) (24 years ago, 31-Aug-02, to lugnet.robotics)
|
| |
 | | Re: RCX 1.0 power adapter
|
|
"Tony Hafner" <lego@NOSPAM.hafhead.com> wrote in message news:H1opsA.EHz@lugnet.com... (...) info (...) of (...) Use a Train power pack. That's what the port had in mind when they made it. I've run pbricks for weeks with no issues. The only (...) (24 years ago, 31-Aug-02, to lugnet.robotics)
|
| |
 | | i2c protocol with the rcx (was Brainstorms)
|
|
Hi, I tested the RCX-to-I2C-board from Elector Electronics. I think it's very good for educating and experimenting where the user learns very much about the protocol and function of the i2c bus. (...) Yes, it's right .... you can use the RCX to (...) (24 years ago, 31-Aug-02, to lugnet.robotics)
|