 | | Re: super cheap tilt sensor?
|
|
"Steve Baker" <lego-robotics@crynwr.com> wrote in message news:3CEAAE66.783CD4...ail.net... (...) rotations (...) Ok... I didn't have any rotation sensors - but now I've bought two from bricklink - that is probably cheaper and easier than buying (...) (23 years ago, 22-May-02, to lugnet.robotics)
|
| |
| | Re: NQC "No reply from RCX" Help Please
|
|
(...) Can you type "nqc" and check to see what version number it prints out? I've double-checked the source code, and it should say "Could not open serial port or USB device". Is it possible there are multiple versions of NQC and your command path (...) (23 years ago, 22-May-02, to lugnet.robotics)
|
| |
| | Re: super cheap tilt sensor?
|
|
(...) It somewhat depends on how rapidly the tilt can change - and whether you intend to try to keep the robot level or just to know how much it's tilted by. For relatively slow rotation speeds, you can use a pendulum with a rotation sensor at the (...) (23 years ago, 21-May-02, to lugnet.robotics)
|
| |
| | RE: super cheap tilt sensor?
|
|
Anybody remember scaleictric controllers? They had a copper coil to control the speed of the cars, as the trigger was pressed it would move the bar(in power) thru the coil and voltage would increase. This could be an easy and safe way! Rob (...) (23 years ago, 21-May-02, to lugnet.robotics)
|
| |
| | Re: Designing a bipedal robot leg
|
|
(...) links (...) up. I used that in my beginning research on what has been done with Lego legs. :D I actually was going to it Friday, but Geocities was down all weekend. Saw it yesterday though. (...) (URL) built that leg over the weekend too, but (...) (23 years ago, 21-May-02, to lugnet.robotics)
|
