To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *32524 (-10)
  Re: RCX Firmware Speed
 
Firstly, thanks very much for that detailed answer. That was exactly the information I was looking for. Somewhere in the thread it was suggested that each task gets one opcode executed every 3ms, actually, as you show, they all get one opcode (...) (25 years ago, 10-Apr-02, to lugnet.robotics)
 
  Re: Light Sensor help
 
(...) 16 MHz AFAIK, and I bet it could go much faster, at the price of a less reproducible timing. leJOS executes some tens of Java bytecodes per millisecond, an empty 10000 iterations loop containing four relatively simple byte codes runs in 1.4 (...) (25 years ago, 10-Apr-02, to lugnet.robotics)
 
  RCX Firmware Speed
 
This is a follow up to many of the recent posts on the speed of Lego's RCX byte code interpreter. It's a long post but the salient items are in the first few paragraphs. The interpreter is very slow because of all the overhead required to execute a (...) (25 years ago, 10-Apr-02, to lugnet.robotics) ! 
 
  Re: Light Sensor help
 
(...) Hrm. Looks like I need to be more thorough with my multi-task timing tests... my results (which seemed to show only one task getting run in any given timeslice) differ from yours. Unfortunately, I didn't keep good notes of all my measurements, (...) (25 years ago, 10-Apr-02, to lugnet.robotics)
 
  SpyBots @ Amazon
 
The upcoming SpyBots are listed for preorder at Amazon. No pictures yet, but the names and a short description are given for each. MSRP looks to be $60 each. Check it out: (URL) (25 years ago, 10-Apr-02, to lugnet.robotics)
 
  RoboLab newsgroup page updates
 
The RoboLab newsgroup page (URL) some updating. The first two links on the left pane don't work anymore. The following two links should replace those first two links: Tufts RoboLab site (URL) or (URL) Education (Dacta) RoboLab site (URL) Pitsco site (...) (25 years ago, 10-Apr-02, to lugnet.admin.suggestions, lugnet.robotics.rcx.robolab, lugnet.dacta)
 
  RoboLab updates
 
If you only read the Robolab newsgroup then you may have missed a helpful post that did not appear in the RoboLab newsgroup. If so, then look at: "Robolab 2.5 patches" (URL) (25 years ago, 10-Apr-02, to lugnet.robotics.rcx.robolab)
 
  Re: Light Sensor help
 
(...) Well, I can think of lots of reasons why you might want trig - if you know what direction you are moving in and how far you've travelled, trig will let you figure out where you are relative to where you started. Using an NQC lookup table isn't (...) (25 years ago, 10-Apr-02, to lugnet.robotics)
 
  Re: Light Sensor help
 
Yuck How much time is the brick spending sleeping then? Roland (...) (25 years ago, 10-Apr-02, to lugnet.robotics)
 
  Re: Light Sensor help
 
(...) Yes, it all appears to be synchronous. However, only one bytecode instruction is run in any given 3ms; any active tasks interleave their instructions. If you have two tasks running, they will each be getting an instruction every other 3ms. If (...) (25 years ago, 10-Apr-02, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR