 | | New Expansionboard
|
|
Hi all We at the TWI (School of engineering, www.twi.ch) in Switzerland are using the Handyboard for several projects. One of them is a model car with ultrasonic sensors and model servos. Because of some limitations of the Handyboard we have built a (...) (29 years ago, 8-Dec-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: High current speed controllers
|
|
Thomas, We are using the HB to control an AstroFligt 50A controller. The controller comes standard with a 20K pot to vary the PWM signal. What I did as substitute the 20K pot with a DallasSimi DS1803 pot. Its a 14 (I think) dip package that uses I2C (...) (29 years ago, 8-Dec-97, to lugnet.robotics.handyboard)
|
| |
 | | Interrupt Programming
|
|
We are building a mobile robot using the Handy Board and we desperately need help. To read into the sensors, we are programming using Interactive-C interupts. Would this be a good idea, and if so how do you do it as we are not quite sure. Are there (...) (29 years ago, 8-Dec-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: tracking an IR beacon
|
|
The phase difference seen by the sensors would be tiny at any practical frequency. Assume that you have the sensors a distance, D, apart and facing 'forward' on the robot. If there is a transmitting source at 90 degrees to the forward direction, the (...) (29 years ago, 8-Dec-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: tracking an IR beacon
|
|
(...) I confirm what David is saying! Once i worked on some kind of beacon using an PLL to find its frequency (we used a lm567) and it couldn't work properly due to the response time of the PLL. An alternate solution was to replace the PLL by a (...) (29 years ago, 7-Dec-97, to lugnet.robotics.handyboard)
|