To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3031 (-5)
  Re: IC problem
 
Jeremy, You have to give us more information about what you've tried. Have you re-downloaded pcode_hb.s19 to your board? Do you get the boot beep and LCD message when you turn your board on? Have you changed your desktop computer configuration at (...) (29 years ago, 1-Dec-97, to lugnet.robotics.handyboard)
 
  Re: IC problem
 
(...) Hi Jeremy, My board does that sometimes too. Are you useing the same telephone cable? Make sure all other programs are closed on your computer. Reset the board by turning it off and then back on. Good luck Terry (29 years ago, 30-Nov-97, to lugnet.robotics.handyboard)
 
  Robotics club in the Los Angeles area.
 
Does anybody know of a club in the Greater LA area. The only one I've found so far is over an hours drive away. Any info would be helpful. Thanks Mike (29 years ago, 30-Nov-97, to lugnet.robotics.handyboard)
 
  IC problem
 
Hi guys, I know that this exact question came up once before in this newsgroup, but its reply has long since gone to the bit bucket in the sky, so forgive me. Anyway, I can get the following message on my handy-board: Interactive C V 2.81 9/28/93 (...) (29 years ago, 29-Nov-97, to lugnet.robotics.handyboard)
 
  Re: Smoking serial/charger board...!!!
 
I am having a similar problem (see notes below) - R11 is burning on the serial/charger board. My HB had been on the shelf for a month or so, and it may have been left on AND I had made the motor-power hack (I tapped the center of the battery pack to (...) (29 years ago, 28-Nov-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR