 | | IR Demodulator Range Finder Hack
|
|
A few months ago I found information on how to modify the Sharp IR Demodulator to produce an analogue voltage relating to the strength of IR received. The problem is that I have lost the information and can't remember where I saw it. Has anybody (...) (29 years ago, 17-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | Ooops.
|
|
Help! I accidently plugged a network rj11 cable between my HB and the serial interface board. It seems that I released the smoke genie from R 11. I have replaced the resistor and the MAX 232 but I'm not getting the board to sync. Is there anything (...) (29 years ago, 16-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | Shaft Encoders
|
|
While looking through the code 'pcode.asm' I came accross reference to various encoder routines that enable Y0 and get RSE code from the data bus. How can I call these within a C Programme ? I've not seen this feature documented anywhere (or maybe (...) (29 years ago, 15-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | Motorola Reference Guides
|
|
I just got the set of Motorola HC11 guide books and reference manuals. I can highly recommend them - I am now able to understand the processor better, and how to take advantage of its many facilities. However when requesting them from the web site I (...) (29 years ago, 15-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: IR devices
|
|
The IR led I assume would be the transparent one and the detector would be the black one? There are 2 leads on the transmitter and 3 on the detector, how and where should I connect it to the HB? Any diagrams available? If this works, I have about 10 (...) (29 years ago, 14-Nov-97, to lugnet.robotics.handyboard)
|