Subject:
|
Ooops.
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sun, 16 Nov 1997 05:38:31 GMT
|
Original-From:
|
Michael Chang <mchang@%SayNoToSpam%westworld.com>
|
Viewed:
|
1318 times
|
| |
|
|
Help!
I accidently plugged a network rj11 cable between my HB and the serial
interface board. It seems that I released the smoke genie from R 11. I
have replaced the resistor and the MAX 232 but I'm not getting the board
to sync. Is there anything other than the parts that I replaced that
could be damaged? Like the mcu? This would be a bummer.
Any help or sugestion would be greatly appreciated.
Mike
|
|
Message has 1 Reply:
 | | Re: Ooops.
|
| It's unlikely you killed the MCU, there are 1k resistors in series with the RxD and TxD lines. Go to the assembly manual, and run through the series of tests that verify proper operation of the Interface/Charger Board. (URL) your message you said: (...) (27 years ago, 17-Nov-97, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
