 | | Expansion Board
|
|
It would be nice to see a set of raw, addressed digital OUTPUTS (as well as) analog OUTPUTS on the board. Maybe they are already on the handy board itself, however, they are not addressed on the data bus. The IC code libraries needed for this would (...) (29 years ago, 10-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | L239
|
|
Does anyone know of a good source for the L293D or th TI SN754410? Future Electronics has them, but they want roughly $9.00 per chip. I am just looking for 4, but I don't want to be charged an arm and a leg to get them. Thanks ___...___ ___...___ (...) (29 years ago, 10-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: Burning hot motor driver chips.
|
|
Anthony, As you've no doubt heard, RC motors take much more current than the Handyboard can supply. To control RC motors your only choice is to create a separate H-bridge to drive the motors. You can do this fairly inexpensively with power (...) (29 years ago, 10-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: IR devices
|
|
Hi Jeremy! I used the shaft encoder out of a track ball for my robotic project(same thing but a bit bigger). You do not need the IC out of the mouse just take the shaft encoder and use it with a IR led and detector pair. If you are going to use the (...) (29 years ago, 10-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: Burning hot motor driver chips.
|
|
Hello, RC car motors pull a lot of current, from 2A to 8A. The L293D chip goes up to 1A peak (for some miliseconds) before it shuts down. I suggest bypassing the L293D chips and using something like the LMD18200. (URL) Good luck, Marco A.A. de (...) (29 years ago, 10-Nov-97, to lugnet.robotics.handyboard)
|