 | | Project Questions
|
|
Three of us are undertaking a project using the Handyboard as the control system for a class at MIT. Our project, an autonomous blimp, has an unusual set of constraints, but we're hoping that your collective experience might be able to help us (...) (29 years ago, 9-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: Burning hot motor driver chips.
|
|
(...) sounds reasonable.. which "car" BTW? Some may be using that very same platform and may have some timely advice for you. (...) sounds like overload/overheating cutoff to me. (...) This is from the Handy Board FAQ : <---snip---> It is possible (...) (29 years ago, 9-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: Burning hot motor driver chips.
|
|
Anthony, (...) Yes it sounds like it. (...) It does. The L293D still works after it cools off, doesn't it? (...) I suspect you are going to need more than just two piggy backed L293D. (...) You might have a look at Ben Wirz website, he sells various (...) (29 years ago, 9-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | Burning hot motor driver chips.
|
|
After not doing anything with my HB for a few months, I decided to buy a cheap RC car and use it as a platform. Anyway, I get a car that takes 6 AA batteries because I figure that the main motor is probably 9v (maybe that was a faulty assumption). (...) (29 years ago, 9-Nov-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: Shaft Encoders
|
|
(...) We used the line of "S1" optical encoders from US Digital Corp. ((URL) and found them to work superbly. The encoders are light (~.07 lb) and small (~1.7" x 1.3"). The company is a "Value Added Retailer" and adds housings/bearings/whathaveyou (...) (29 years ago, 8-Nov-97, to lugnet.robotics.handyboard)
|