To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *29229 (-5)
  Display the value of Scout sensors
 
Scout is cheaper, but when you debug NQC program in Scout, you have no way to watch the value of its sensors, I made a small program that can show sensors value in a RCX LCD, you can use remote to change watching sensor, message 1 for sensor1, (...) (25 years ago, 26-Jul-01, to lugnet.robotics.rcx.nqc, lugnet.robotics.scout)
 
  Re: Got my RIS 2.0 set
 
(...) [snip] (...) Hi Tilman, thanks a lot for the info. I personally don't use RCX Code to write my programs, but IMO the addition of variables and instructions to manipulate them is the most important change. This makes the software much more (...) (25 years ago, 26-Jul-01, to lugnet.robotics)
 
  RE: To whoever has RIS 2.0...
 
There's no part number on it. The cable is permanently attached to it. The new tower is a very different beast than the old one. It does not show up as a serial port on your system. I'm pretty sure you will need the 2.0 software to use it. That's (...) (25 years ago, 26-Jul-01, to lugnet.robotics)
 
  RE: Got my RIS 2.0 set
 
(...) I was talking about the new USB tower, not the RCX. The RCX is visually unchanged, except for the "2.0" inscription on the side. Tilman (25 years ago, 25-Jul-01, to lugnet.robotics)
 
  RE: Got my RIS 2.0 set
 
(...) Doesn't that mean the ROM must have been changed? IIRC the RCX 1.0 could not do VLL... Chris (25 years ago, 25-Jul-01, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR