Subject:
|
RE: To whoever has RIS 2.0...
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Thu, 26 Jul 2001 08:06:27 GMT
|
Original-From:
|
Tilman Sporkert (webMethods) <tilman@webmethods.{StopSpam}com>
|
Viewed:
|
1680 times
|
| |
|
|
There's no part number on it. The cable is permanently attached to it.
The new tower is a very different beast than the old one. It does not show
up as a serial port on your system. I'm pretty sure you will need the 2.0
software to use it. That's where you get the USB driver and the Windows
Control Panel entry. The pre-2.0 software, including alternative products
like nqc, all talk the serial port directly.
Tilman
> -----Original Message-----
> From: news-gateway@lugnet.com [mailto:news-gateway@lugnet.com]On Behalf
> Of rhendrix
> Sent: Wednesday, July 25, 2001 11:18 AM
> To: lego-robotics@crynwr.com
> Subject: To whoever has RIS 2.0...
>
>
> What is the part number for the IR tower and cable? I'm going to try to
> finagle(sp?) my way into one. Or...tell me the difference in the
> internals
> of the new usb tower and the old serial tower. I might could
> install a new
> cable and upgrade my software (although I think 1.5 software would be
> sufficient for this).
|
|
Message is in Reply To:
 | | To whoever has RIS 2.0...
|
| What is the part number for the IR tower and cable? I'm going to try to finagle(sp?) my way into one. Or...tell me the difference in the internals of the new usb tower and the old serial tower. I might could install a new cable and upgrade my (...) (25 years ago, 25-Jul-01, to lugnet.robotics)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
