 | | Re: Yet another Q: IR messages
|
|
To send a message use the following: SendMessage(<variable> or <number>); The variable must be of integer type between 1 - 255 The number must be between 1 - 255 To read a message from the IR port do <variable> = Message(); This will put whatever (...) (26 years ago, 29-Mar-01, to lugnet.robotics.rcx.nqc)
|
| |
 | | Re: Yet another Q: IR messages
|
|
Hi Tobias, this could look something like this for example : int global_message; // place to store and read messages for every task task main() { start Read_Messages; // start Receive_Message Task while(true) { switch (global_message) { case 1 : (...) (26 years ago, 29-Mar-01, to lugnet.robotics.rcx.nqc)
|
| |
 | | Re: Shutting off illumination LED on Light Sensor for LIDAR
|
|
(...) Thanks for all the tips, everybody. I set out last night to open up my light sensor and add a jumper to allow me to take the LED out of the circuit. I was unsuccessful in getting the casing open, even after cutting the underside latching tabs (...) (26 years ago, 29-Mar-01, to lugnet.robotics)
|
| |
 | | Re: lego cap, polarity, etc
|
|
(...) <snip> The polarity markings Andy Gombos was referring to are printed on the LEGO-compatible package itself. The LEGO "capacitor" is in fact an electrolytic cap with plenty of support circuitry, and I assure you there is no danger of blowing (...) (26 years ago, 29-Mar-01, to lugnet.robotics)
|
| |
 | | Yet another Q: IR messages
|
|
I can't figure out how to use the IR commands. I've tried, read a bit in the documentation, but still have no clue. I'd like to know how to: a) Send a message (and decide what message it should be) and b) learn how to recieve messages Thanks in (...) (26 years ago, 29-Mar-01, to lugnet.robotics.rcx.nqc)
|