 | | Re: NQC 2.31b 1 and the RCXcc
|
|
----- Original Message ----- From: "Miles Gentry" To: <lugnet.robotics@lugnet.com> Subject: Re: DDK - What use are they / lower prices seen> To go to an even higher level, after you get the new NQC, then get RCX2 (...) On the download page it says: (...) (26 years ago, 26-Feb-01, to lugnet.robotics)
|
| |
 | | Black friction peg size
|
|
While I was makeing a simply fixture to mount black friction pegs in a lathe, I discovered that they come in two different wall thicknesses! I had never seen a posting about this and I had never noticed it before, but it accounts for why some things (...) (26 years ago, 26-Feb-01, to lugnet.robotics)
|
| |
 | | Wall transformer for RCX
|
|
I have seen a number of post asking the same question, What to use for external power for the RCX (ver 1.0) I have been using RadioShack; cat # 273 1631 - 9v 800mA AC This transformer has the correct size jack. The output voltage is adjustable. I (...) (26 years ago, 26-Feb-01, to lugnet.robotics)
|
| |
 | | How big is too big?
|
|
I have a NQC program that is not working properly. However, when ever I complie and run a smaller section of the code it works fine. The basics of the code is the following: 1. wait until you get a valid message from RCX1 (code is for RCX2) 2. go (...) (26 years ago, 26-Feb-01, to lugnet.robotics)
|
| |
 | | Re: DDK - What use are they / lower prices seen
|
|
(...) These are (far better) comments than I was going to make wrt to scout and micro-scout. Essentially, the scout and micro-scout allow you to experiment with team and cooperative robotics--as Miles said: "a higher level". I bought my 7.5 YO son a (...) (26 years ago, 26-Feb-01, to lugnet.robotics)
|