 | | Re: Visual NQC 2001
|
|
<Runtime error 380 fix If you get Runtime error 380 during compile start you need to change the subdirectory where NQC.exe is stored. Use a directory without a space in the name. Example C:\NQC\nqc.exe This will work.> That did not work. I am still (...) (26 years ago, 1-Feb-01, to lugnet.robotics.rcx.nqc)
|
| |
 | | Re: Anyone using Mac beige G3
|
|
(...) One thing to keep in mind about Mac serial ports is that they are not RS-232, rather they are RS-422. IIRC, RS-232 is a singled-ended voltage standard (ref to ground only), where RS-422 is a differential standard. The 'common' method of using (...) (26 years ago, 1-Feb-01, to lugnet.robotics.rcx.nqc)
|
| |
 | | Re: Pneumatic tubing...
|
|
(...) I suppose you could check medical supply shops... You could also try www.newark.com, and request a catalog. If you are using Netscape Communicator, just type "pneumatic tubing" (without the quotes) into the URL field, and start with those (...) (26 years ago, 1-Feb-01, to lugnet.robotics)
|
| |
 | | RE: 68HC11 (Evaluation Board)
|
|
I was wondering if anyone was aware of any pre-existing library calls that would allow an individual using an Evaluation Board (EVB-68HC11)+ Buffallo Monitor(ImageCraft C v5.0) to access the system clock. I've noticed that with using Interactive C (...) (26 years ago, 1-Feb-01, to lugnet.robotics.handyboard)
|
| |
 | | Re: Pneumatic tubing...
|
|
Dear Tom (...) Thanks for your reply. You'll notice that I mentioned in my original question that the tubing available in the RC shops (which I referred to as poly tubing rather than neoprene -- my bad) is a bit stiff. I had a vague memory of (...) (26 years ago, 1-Feb-01, to lugnet.robotics)
|