To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *2561 (-5)
  Re: 3V motors
 
I too had a problem with 3 volt motors. The issue is the height of the PWM output. If you drive your motor function at 50%, then 50% of 9.6V is still much higher than the 3 VDC for full speed. One way to get some resolution is to modify the supply (...) (29 years ago, 6-Aug-97, to lugnet.robotics.handyboard)
 
  Motors
 
Hi. I am running two 3.3V motors with the handy board. Sometimes The motors would just stop running. The leds that indicates the motors are running are still lit. Also the two chips next the motor output gets very hot. The number on the chip is (...) (29 years ago, 6-Aug-97, to lugnet.robotics.handyboard)
 
  MAgentic card readers again...
 
Anyone can help me about the way to connect a magnetc card reader to the handy? I use the idea from david negro , that use the SPI port, but i don't can make work the code... Can anyone tell me uf exists other source of that info ont the web?? (...) (29 years ago, 6-Aug-97, to lugnet.robotics.handyboard)
 
  Re: IR output on HB
 
No, don't use a transistor! The HB's IR out already has one. But the parallel-with-a-sepa...r-for-each method is correct. -Fred In your message you said: (...) (29 years ago, 5-Aug-97, to lugnet.robotics.handyboard)
 
  Re: IR output on HB
 
Run them in parallel, use a transistor. Like so: +5v | +---+---+---+---+---+ | | | | | | \ \ \ \ \ \ / R / R / R / R / R / R \ 1 \ 2 \ 3 \ 4 \ 5 \ 6 / / / / / / -- -- -- -- -- -- \/ \/ \/ \/ \/ \/ -- -- -- -- -- -- HB + | | | | | | \ | | | | | | / (...) (29 years ago, 5-Aug-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR