Subject:
|
Motors
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 6 Aug 1997 15:39:11 GMT
|
Original-From:
|
Souhow <(sear01@utopia)NoMoreSpam(.poly.edu)>
|
Viewed:
|
1275 times
|
| |
| |
Hi. I am running two 3.3V motors with the handy board. Sometimes
The motors would just stop running. The leds that indicates the motors are
running are still lit. Also the two chips next the motor output gets very
hot. The number on the chip is "SN754410NE". Could this problem be cause
by the fact that the HB outputs 9V? I set the power setting the lowest
possiable value bu the problem still occurs.
Souhow
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|