To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *25594 (-5)
  Re: VB SDK for RCXs
 
The VB SDK is on the LEGO Mindstorms page under the Master Coders SDK area. A word of warning, I looks like 2.0 does not use the OCX that VB uses. You may want to explore the 2.0 software. James J. Trobaugh <james@ngltc.org> wrote in message (...) (26 years ago, 29-Dec-00, to lugnet.robotics.rcx)
 
  Re: Lightsensor
 
Are you saying that if you shine a bright light into the sensor it only goes up to 47, or is that the reading you get reflected from white paper. You should get 100 when you shine a light into it. Thomas Ruhmann <truhmann@s-direktnet.de> wrote in (...) (26 years ago, 29-Dec-00, to lugnet.robotics.rcx)
 
  9V Lamp Source
 
Hello All! Where can I find a good source of the 9V lamps that are available in the Ultimate Accessory set, 3801? The lamp in question is 1x2 white brick with a small bulb. I'd like to get several of these, maybe in other colors (brick, not bulb) if (...) (26 years ago, 29-Dec-00, to lugnet.robotics)
 
  Re: Power inlet to RCX 1.5?
 
You could use a voltage regulator at the adaptor output. You would not get anything above the rated voltage, but I do not know about lower voltages. Andy (...) (26 years ago, 29-Dec-00, to lugnet.robotics)
 
  Re: Power inlet to RCX 1.5?
 
Some people already discussed it in the past but I don't remember nobody saying that it was already done. I'm very interested in this matter also. One idea was do use a wire with aligator clips connected to the internal baterry connectors. You may (...) (26 years ago, 29-Dec-00, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR