To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *2556 (+5)
  Re: CdS cells
 
[David.J.Dostal@lawrence.edu] spake unto the ether: (...) I just ordered some from Mouser, the smaller of the two physical sizes they have, 3K to 100K I believe are the light/dark resistances. These give analog(PORT) values of about 10 in ordinary (...) (29 years ago, 5-Aug-97, to lugnet.robotics.handyboard)
 
  Re: IR output on HB
 
Run them in parallel, use a transistor. Like so: +5v | +---+---+---+---+---+ | | | | | | \ \ \ \ \ \ / R / R / R / R / R / R \ 1 \ 2 \ 3 \ 4 \ 5 \ 6 / / / / / / -- -- -- -- -- -- \/ \/ \/ \/ \/ \/ -- -- -- -- -- -- HB + | | | | | | \ | | | | | | / (...) (29 years ago, 5-Aug-97, to lugnet.robotics.handyboard)
 
  Re: IR output on HB
 
No, don't use a transistor! The HB's IR out already has one. But the parallel-with-a-sepa...r-for-each method is correct. -Fred In your message you said: (...) (29 years ago, 5-Aug-97, to lugnet.robotics.handyboard)
 
  MAgentic card readers again...
 
Anyone can help me about the way to connect a magnetc card reader to the handy? I use the idea from david negro , that use the SPI port, but i don't can make work the code... Can anyone tell me uf exists other source of that info ont the web?? (...) (29 years ago, 6-Aug-97, to lugnet.robotics.handyboard)
 
  Motors
 
Hi. I am running two 3.3V motors with the handy board. Sometimes The motors would just stop running. The leds that indicates the motors are running are still lit. Also the two chips next the motor output gets very hot. The number on the chip is (...) (29 years ago, 6-Aug-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR