 | | Re: servos?
|
| (...) Phil, Have you tried this site: www.robotstore.com ? They have servos in discount packs as well as serial controllers for them. Cheers Massimo Piccoli -only wanting to know something new puts you a step forward- (29 years ago, 1-Aug-97, to lugnet.robotics.handyboard)
| | |  | | RE: servos?
|
| The best places are the mail order hobby stores. They have the widest selection of servos and very good prices. The two I recommend are Tower Hobbies (www.towerhobbies.com) and Hobby Shack (www.hobbyshack.com). Either of these sells servos cheaper (...) (29 years ago, 1-Aug-97, to lugnet.robotics.handyboard)
| | |  | | Re: Voltage problem
|
| Well, further experimentation revealed that the chips are working, but with a quirk: If the the input of the '232 (pin 10) is tied to ground (pin 15), then the output (pin 7 of the '232, or pin 3 of J9) goes to the expected value of ~+10 volts. If, (...) (29 years ago, 1-Aug-97, to lugnet.robotics.handyboard)
| | |  | | RC bot base
|
| Hello All, I have just purchased a new TYCO 9.6V Zig Zag car. It seems to have a fairly good base w/treads. I connected it to the handyboard (after gutting it and extending the wires ). Next I gave the motors a test and they both ran way too fast. (...) (29 years ago, 1-Aug-97, to lugnet.robotics.handyboard)
| | |  | | int/float to string routines?
|
| Are there any int/float to string conversion routines available for the handy board? I'm sending data over the HB's serial port to my PC, and I need to be able to send data in string format. (I was originally sending data in its actual byte value, (...) (29 years ago, 2-Aug-97, to lugnet.robotics.handyboard)
| |