 | | Re: motorized points - beating a dead horse
|
|
There's a lot of activity around Lego trains. Clubs, fans, shows, web sites, and lots more. If you look around, you should find some suggestions. Try this page for starters: (URL) a page with some information on point motors: (URL) (26 years ago, 1-Dec-00, to lugnet.robotics)
|
| |
 | | Re: motorized points - beating a dead horse
|
|
(...) (note some heavyhanded snippage) Well, it wouldn't be entirely elegant unless you mounted the mechanics under your substrate, but if you were to gear down the movement so that the white clutch gear had to exert less torque to overcome the (...) (26 years ago, 1-Dec-00, to lugnet.trains, lugnet.robotics)
|
| |
 | | Re: motorized points - beating a dead horse
|
|
Steve, If you are willing to use non-lego parts, there is a reliable solution. You can build a limit switch that does not use any sensor inputs. You need two "normally closed" switches, and two diodes. Solder a diode across each switch. Wire the (...) (26 years ago, 1-Dec-00, to lugnet.robotics)
|
| |
 | | Re: motorized points - beating a dead horse
|
|
Try putting belt drive stage in your geartrain so it can't destroy things and use touch switches to limit the travel... (26 years ago, 1-Dec-00, to lugnet.trains, lugnet.robotics)
|
| |
 | | Re: Communication between NQC and VisualBasic
|
|
In article <G4uLMp.1tL@lugnet.com>, "Richard Sutherland" <richard@webbox.com> wrote: here...it would just be putting another level of abstraction between the (...) IR Messages are implemented, although in the simulated environment they result in (...) (26 years ago, 1-Dec-00, to lugnet.robotics.rcx.nqc)
|
| |
 | | Re: Communication between NQC and VisualBasic
|
|
(...) Unfortunately, Spirit.ocx doesn't support sending messages. However, the packet protocol is pretty simple so as long as you can access the serial port directly you should be able to build message packets. See the following web pages for more (...) (26 years ago, 1-Dec-00, to lugnet.robotics.rcx.nqc)
|
| |
 | | Re: Using a Sony Remote control to run my Mindstorms...
|
|
Not a problem. J- (...) (26 years ago, 30-Nov-00, to lugnet.robotics.rcx)
|
| |
 | | Re: motorized points - beating a dead horse
|
|
I didn't take pictures, but I did it w/ some gearing and clever placement of a touch-sensor. The key part was that the touch sensor (though light or rotation would work) would sense when the switch was vertical; I then used the motor like a big (...) (26 years ago, 30-Nov-00, to lugnet.robotics)
|
| |
 | | motorized points - beating a dead horse
|
|
Hi All, Currently I am attempting to build an automated hump yard. The main problem I'm tackling is the RCX controlled motorized points. I've spent 7 hours over the last two days trying to build a motorized switch track that will run forever with (...) (26 years ago, 30-Nov-00, to lugnet.trains, lugnet.robotics)
|
| |
 | | Re: SDK2.0 on RCX1.5?
|
|
(...) Yes, the firmware works GREAT in the 1.x bricks. Dean -- Coin-Op's For Sale!: (URL) Lego Workshop: (URL) Lego Club: (URL) (26 years ago, 30-Nov-00, to lugnet.robotics.rcx)
|