 | | Re: Communication between NQC and VisualBasic
|
|
It seems that you want to run an RCX emulator on the PC side that can use the PC IR Tower as if it was the internal transmitter in the RCX brick. Thus you could run NQC generated bytecode in your robot, and NCQ generated bytecode on your PC. I know (...) (26 years ago, 30-Nov-00, to lugnet.robotics.rcx.nqc)
|
| |
 | | Re: AW: Navigation by sound?
|
|
Hi :) I was going to write about the need for the minimum of 3 point for a perfect TRIangulation etc.. but then, it just ocurred to me: One can use this err... "BIangulation" (eheh) technic (in theory... I just thought of this right now)) to direct (...) (26 years ago, 30-Nov-00, to lugnet.robotics)
|
| |
 | | Re: Bugs in RoboLab?
|
|
I thought I would pass on what I have learned. Robolab sends very different code to the RCX than you might assume. For example, "Wait for Rotation" will always clear the rotation sensor first! There are a number of other anomalies, such as the (...) (26 years ago, 30-Nov-00, to lugnet.robotics.rcx.robolab)
|
| |
 | | Re: Recipricating motion problems
|
|
sorry but you lost me, whats a cam? If you mean an off center 40 tooth gear, i already tried that but it didn't work. i could get it to turn th other , but i could get it to turn it back again Jason (...) (26 years ago, 30-Nov-00, to lugnet.robotics)
|
| |
 | | Re: Recipricating motion problems
|
|
You need gears or a cam that allows an adjustment in the distance from the centerline of the shaft. A 24 tooth gear and a 40 tooth gear would allow you to accomplish such action. I find the cam is very useful as the driven element. You can always (...) (26 years ago, 30-Nov-00, to lugnet.robotics)
|