 | | Re: LinuxPPC and "No response from RCX" problem
|
|
(...) Did you set the correct permissions for the serial ports (normally they're only accessible by root under Linux) Do a chmod 777 for /dev/ttyS0 (26 years ago, 3-Nov-00, to lugnet.robotics.rcx.nqc)
|
| |
 | | LinuxPPC and "No response from RCX" problem
|
|
Hi, I recently bought an RIS kit and from my Windows box it works fine. When I try using LinuxPPC off my PPC Amiga I get the following: [root] /home/chris/nqc/nqc-2.2.r2 >bin/nqc -v -raw 10 Tx: 55 ff 00 10 ef 10 ef Rx: 55 ff 00 10 ef 10 ef Tx: 55 ff (...) (26 years ago, 3-Nov-00, to lugnet.robotics.rcx.nqc)
|
| |
 | | Re: How2 'count' in NQC
|
|
In lugnet.robotics, Jerry Kalpin writes: [SNIP] (...) There is an EDGE mode available through the firmware that only counts transitions between pressed and non-pressed (actually some raw threshold value if I remember correctly) states. This sensor (...) (26 years ago, 3-Nov-00, to lugnet.robotics)
|
| |
 | | Re: How2 'count' in NQC
|
|
I have noticed this ongoing thread about the difficulties of debouncing and counting switch closures, and I must say that it is a very real problem anywhere electromechanical switches are interfaced to electronics which is orders of magnitude (...) (26 years ago, 3-Nov-00, to lugnet.robotics)
|
| |
 | | Re: How2 'count' in NQC
|
|
Steve, this is the third time you have helped me, and this time you obviously spent a lot of time working out the alternatives. First of all, the Wait (DELAY); in my inept code was not to flash every half second. It was to prevent additional counts (...) (26 years ago, 3-Nov-00, to lugnet.robotics)
|