To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *2436 (-5)
  RE: Corrupted or Invalid Pcode?
 
I've discovered the problem. When I mounted the Handyboard, I used metal standoffs. When the board is mounted, it doesn't work. When it isn't, it does. The solution then I guess is to use nylon washers to isolate the Handyboard from the standoffs. (...) (29 years ago, 11-Jul-97, to lugnet.robotics.handyboard)
 
  Re: Sourcecode of pcode_hb.s19
 
(...) go to the Software Resources page ... look for link titled "Interactive C Source". -Fred (29 years ago, 11-Jul-97, to lugnet.robotics.handyboard)
 
  Sourcecode of pcode_hb.s19
 
Hi! I'm looking for the source code of pcode_hb.s19 because I like to replace the motor driver source. Do anybody have or know where to find the source code? Thanks tom (29 years ago, 11-Jul-97, to lugnet.robotics.handyboard)
 
  Re: IR connection
 
(...) Howdy- I put mine into the analog ports, but not directly- here's how I do it- +Volts o | / R1 \ 47K / \ | "Analog" Out R2 1K | >------\/\/\-------o---...---> | Sensor In --- C1 --- 10uF | | ----- --- - You may discover that you need to alter (...) (29 years ago, 10-Jul-97, to lugnet.robotics.handyboard)
 
  Re: IR connection
 
(...) Hi, You should plug the detecvtor into a digital port. (...) (29 years ago, 10-Jul-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR