To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *23419 (-10)
  Re: RCX 1.0 and RCX 1.5 - ANY differences???
 
(...) I've been running the alpha 2.0 firmware on my 1.0 RCX for a while now. Works great, extra features are useful. (26 years ago, 1-Sep-00, to lugnet.robotics.rcx)
 
  Re: IR Ball (was Soccer-Playing Robots)
 
Wilcox, Doug writes: > I need a schematic (or--in reality--at least a resistor value, whether the > LEDs are parallel or in series, and the battery voltage used) to wire the > LEDs without burning them out, but my biggest challenge will be finding a (...) (26 years ago, 1-Sep-00, to lugnet.robotics)
 
  Re: IR Ball (was Soccer-Playing Robots)
 
(...) Just wanted to share some other informations that are currently being discussed by email: I used a Philips IR LED intended to be used for TV remote control, it works well with 1-1,2 V and in this range absorbs about 8-10 mAh. I used a battery (...) (26 years ago, 1-Sep-00, to lugnet.robotics)
 
  Re: Vision Command
 
(...) The camera is compatible with the VFW and can be used as a general purpose camera with anything that uses VFW. Vision Command on the other hand, does not use VFW and therefore is not compatible with other cameras. Later, Guy (26 years ago, 1-Sep-00, to lugnet.robotics, lugnet.robotics.rcx)
 
  Re: Using a Sony Remote control to run my Mindstorms...
 
(...) A related thought, Radio Shack among others sells remotes that can learn by watching other remotes blink commands and storing them into the remote. One might be able to capture signals from the Lego remote, and perhaps even capture signals (...) (26 years ago, 1-Sep-00, to lugnet.robotics.rcx)
 
  Re: External supply for RCX
 
(...) No one has answered your Question fully so here goes. The RCX with the power Adapter port is the 'old' one. It's power port can take the following: AC or DC (It doesn't matter what direction) AC is a little easier on the RCX as it uses both (...) (26 years ago, 2-Sep-00, to lugnet.robotics)
 
  Re: Info request
 
Take a look at the original reverse engineering of the RCX at (URL) best site for the internals of the RCX with pictures.... Ram PS: You could probably just use wireless serial radio modems for this! It works as follows: PC--->serial (...) (26 years ago, 1-Sep-00, to lugnet.robotics)
 
  Vision Command in Nederland
 
Is Vision Command te koop in Nederland? Zo ja, waar? Does anybody know whether Vision Command is sold in the Netherlands? If yes, where? Harrie de Leeuw Eindhoven The Netherlands (26 years ago, 1-Sep-00, to lugnet.robotics)
 
  Info request
 
Ok, enough's enough! I'm going to take a crack at the IR - RF link thing for the RCX. I'm not promising it's going to be pretty (or cheap) though! But I'll try. First of all, a question - Does anybody know if the schematics for the RCX and more (...) (26 years ago, 1-Sep-00, to lugnet.robotics)
 
  Re: External supply for RCX
 
(...) Yes - but alkaline batteries drop gradually in voltage throughout their lives - by the time they run out, their volts are below 1.2. NiCd's on the other hand stay at 1.2 volts and dry up much more suddenly...over just seconds sometimes. Dunno (...) (26 years ago, 1-Sep-00, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR