To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *2341 (+5)
  servo modification
 
Hi, This is pretty stupid of me, I just figured out how to modify the servos with the help from a document i got at (URL) file TJAM.pdf is in adobe acrobat reader format PDF and it was very helpful. Thanks anyway.... phet (29 years ago, 17-Jun-97, to lugnet.robotics.handyboard)
 
  Re: servo modification
 
Phet, you took off the wrong end. Take the _top_ off the servo and expose the geartrain. Then remove the pot and neuter it as described in the instructions. --Chuck (...) (29 years ago, 17-Jun-97, to lugnet.robotics.handyboard)
 
  I'm happy !!!
 
Boys , I'm really can't believe all the help you give me ... Really, i go to cry of hapiness... But , well I think the better idea ( and most easy of implement ) , is use a digital i/o for detect if exist or not a Handy transmitting to the Pc. My (...) (29 years ago, 18-Jun-97, to lugnet.robotics.handyboard)
 
  Multiple servo control.
 
Has anyone devised a way to control more than 1 or 2 servos from the handy board? I'm talking about 12-14 servos here. Any insight would be appreciated. Thanks in advance. -Cris ---...--- E. Crispell Wagner Department of Computer Science and (...) (29 years ago, 18-Jun-97, to lugnet.robotics.handyboard)
 
  servo modification
 
Hi, After going through various files about servos and how to modify them into dc motor with gear head, there seem to be in general three ways to modify them. One of them was to take out the pot and replace it with two 2.7k resistor in series; (...) (29 years ago, 18-Jun-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR