 | | Re: LegOS on LinuxPPC
|
|
In article (...) I have had better luck with egcs-1.1.2 rather than gcc 2.95.2. I've heard that there's a problem with the way gcc 2.95.2 generates code for memcpy. I've also heard that the fix is to use an assembly version of memcpy instead of (...) (26 years ago, 11-Jul-00, to lugnet.robotics.rcx.legos)
|
| |
 | | LinuxPPC gcc errors
|
|
Ok, I have some error messages here. I'm following the exact instructions in the HOWTO, except for using gcc 2.95.2 instead of egcs 1.1.2. I recall trying egcs with similar results. The make proceeds fine for a while. Then I get this message, and (...) (26 years ago, 11-Jul-00, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: Pneumatics and its uses
|
|
(...) What sort of prices are we talking about here? I found some small, low power electronic valves here in Australia; (geez there's a lot of terminology in this industry) they cost $126!! Ouch! I was thinking that you might be able to get (...) (26 years ago, 11-Jul-00, to lugnet.robotics)
|
| |
 | | Re: gluing pneumatic hoses
|
|
How about cutting a short piece from one of those stiff Lego pipes. Pneumatic hoses slip onto these for a tight fit. Then drill a small hole for the pipe (not the hose) into the back of the suction cup, and insert the other end of the pipe into the (...) (26 years ago, 11-Jul-00, to lugnet.robotics)
|
| |
 | | gluing pneumatic hoses
|
|
Does anyone know of a glue that works on the pneumatic hoses? I am trying to attach them to suction cups so that I can make a window washing robot, but nothing I have tried seems to bond. Thank you for any suggestions, Christopher (26 years ago, 11-Jul-00, to lugnet.robotics)
|