To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *22464 (-5)
  Re: rotation sensor problem, again...
 
I had the same problem and I solved it with a msleep(50). msleep(10) is not enough. (...) (26 years ago, 3-Jul-00, to lugnet.robotics.rcx.legos)
 
  Re: battery life indicator
 
if((BATTERY/0x0016)<700) dlcd_show(LCD_BATTERY_X); I always put this line on my programs. BATTERY/0x0016 gives the value in V*100 of all batteries open circuit voltage. <700 is the limit for rotation sensors to work (all the other sensors have (...) (26 years ago, 3-Jul-00, to lugnet.robotics.rcx.legos)
 
  6.8nF Capacitor
 
I have got all the parts for building my HB except for a 6.8 nF 2% capacitor (component C6). Maplin Electronics have stop doing it and I am not sure where to try next. I am in the UK, does any body know if I can change the resistors in the infrared (...) (26 years ago, 3-Jul-00, to lugnet.robotics.handyboard)
 
  Re: running motors underwater
 
Cool Idea, but take it to it's logical extension ... Use the technic pnuematic elements to maintain positive air pressure in the motor housing. If you pump air into the tubes that you mentioned at a pressure higher than the water pressure, it will (...) (26 years ago, 3-Jul-00, to lugnet.robotics)
 
  Re: running motors underwater
 
(...) It depends alot on what kind of water it's in. Pure distilled water doesn't conduct very well. Water with any kind of ions (salt chlorine, flourine etc) will conduct much better and cause more heating. In addition, the electrolisis that occurs (...) (26 years ago, 3-Jul-00, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR