 | | Re: VB Upload Problem
|
|
You can use RcxCC to simply clear the datalog. Duncan ----- Original Message ----- From: Andy Gombos <lego-robotics@crynwr.com> To: <lugnet.robotics@lugnet.com> Sent: Saturday, June 24, 2000 1:04 PM Subject: Re: VB Upload Problem (...) values. (...) (...) (26 years ago, 24-Jun-00, to lugnet.robotics)
|
| |
 | | Re: VB Upload Problem
|
|
(...) I think chris is putting some other info in the datalog. I poked at this briefly when using an early version of Robolab 2.0, but I don't recall the exact details. I think it comes from Robolab trying to use the datalog to record multiple (...) (26 years ago, 24-Jun-00, to lugnet.robotics, lugnet.robotics.rcx, lugnet.robotics.rcx.nqc)
|
| |
 | | Re: Building a Postscript printer?
|
|
Thanks! I grabbed the HPGL info from wotsit.org. Looking around for Postscript->HPGL converters, I found the following: <ul> <li> <a href="(URL)Pstoedit</a>: converts Postscript and PDF into lots of other vector formats (including HPGL). Source (...) (26 years ago, 24-Jun-00, to lugnet.robotics)
|
| |
 | | Re: Building a Postscript printer?
|
|
There is an online version of the manual(at least part of it--the important parts) available at Wotsit www.wotsit.org. Go to printer formats. There is several formats listed, including PCL and HP-GL/2. Andy (...) (26 years ago, 24-Jun-00, to lugnet.robotics)
|
| |
 | | Re: Building a Postscript printer?
|
|
Yup, that was pretty much what I was planning to do. Hack Ghostscript into something to generate a sequence of vector commands to drive the RCX. I was searching for information on a Postscript->HPGL/PCL converter myself since that is basically what (...) (26 years ago, 24-Jun-00, to lugnet.robotics)
|