To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *21839 (-5)
  Re: Quick Q : 9v Motors
 
(...) There's a big difference - some of the details are here: (URL) Baum (26 years ago, 20-May-00, to lugnet.robotics)
 
  Re: IR communication PC <-> brick with NQC
 
(...) The RCX uses a special packet protocol which involes a lot of binary (non-ASCII) bytes, so controlling it with Hyperterminal won't work very well. Your best bet is to either write your own code to send the packets of the serial port or just (...) (26 years ago, 20-May-00, to lugnet.robotics.rcx.nqc)
 
  Re: Is there a compatible h8 assembler for forth words?
 
(...) A good rule. I just know I'm going to need fast so I am planning ahead. Somehow I'm usually at the bleeding edge of trying to squeeze everything possible out of limited hardware. I originally learned my Forth on a 68000 (Mac Forth on the (...) (26 years ago, 20-May-00, to lugnet.robotics.rcx.pbforth)
 
  RE: Spirograph Formulas??
 
You might enjoy the book "Turtle Graphics" - (URL) - uses the Logo language to control robotic turtles - descibes everything not in the mathematics of analysis but in terms of local geometric movement. Not sure if it has spirograph in it or not, but (...) (26 years ago, 19-May-00, to lugnet.robotics)
 
  RE: Is there a compatible h8 assembler for forth words?
 
(...) No there is not. That being said, it's pretty easy to write one...if you have the time. I fiddled around with it a bit and then gave up since the GNU tools worked pretty quick. It was strictly a time/value exchange. From bitter experience, (...) (26 years ago, 19-May-00, to lugnet.robotics.rcx.pbforth)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR