 | | Re: XCAM confusion
|
|
(...) To follow up on Chris' accurate explanation it works exactly the same way as the Xcam2. The Xcam2 just has 20 feet of cable and a crappy mic. The BEST remote model would be the all in one unit. I have one of all the models and find the latter (...) (27 years ago, 12-May-00, to lugnet.robotics)
|
| |
 | | Re: Scout Questions
|
|
(...) The white gears are a slip gear. To explain it put one on a motor and make it spin. Now grab on to it and it will stop and turn inside. You will notice that there is still a little tension on the gear. It's great for low torque projects where (...) (27 years ago, 12-May-00, to lugnet.robotics.scout)
|
| |
 | | Re: Scout Questions
|
|
If a gear or wheel gets bound, the clutch in the clutch gear slips and protects the motor form burning out. Dennis (...) -- Dennis Williamson - Certified Y2K Complacent Bad News: The next millenium starts on a Monday. Good News: You get the day off. (...) (27 years ago, 12-May-00, to lugnet.robotics.scout)
|
| |
 | | Re: Household Positioning System Re: DGPS
|
|
I see. Humm. May be I can really use this. OK, if I put a few IR LED with ID at different locations in the room, and put them at the same height as the robot sensor so I don't need to worry about tilt angle. If I put the sensor fixed on the robot, (...) (27 years ago, 12-May-00, to lugnet.robotics.handyboard)
|
| |
 | | Re: Household Positioning System Re: DGPS
|
|
Actually, I am going in that direction. I was trying to use the ultrasonic transducer to produce a signal and then use two detector to triangulate the location. That wasn't much of a success. I will need to redo the parts. I want to try using more (...) (27 years ago, 12-May-00, to lugnet.robotics.handyboard)
|