To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *21449 (-10)
  More Znap info please
 
I have been following this Znap thread. Even went to local TRU in Toronto to inquire - the sales associate gave me a look as if I was Znapped :>) What is Znap or a Znap motor? Are they available in the Toronto area? (27 years ago, 26-Apr-00, to lugnet.robotics)
 
  Re: LEGO Pneumatics
 
(...) Uhhh... they still stock them in Denmark, certainly. I had an order through just this week. I ordered it from the UK service centre, but the pack came from Denmark. I just sent them a cheque with the prices from a two-year-old service parts (...) (27 years ago, 26-Apr-00, to lugnet.robotics)
 
  Re: LEGO Pneumatics
 
(...) Hi all I just thought I would let everyone know if you don't already. Lego is no longer producing service packs for pneumatic parts. I guess that would mean no more pneumatic technic sets. The last place to get parts is pitsco. They cost much (...) (27 years ago, 26-Apr-00, to lugnet.technic, lugnet.robotics)
 
  Re: Duplex Comms with RCX
 
(...) I just haven't found a non-intrusive method for keeping the tower alive. I hate transmitting garbage every few seconds and possibly trampling incoming data. I'm also not sure this is a very good long-term solution. Really a general purpose (...) (27 years ago, 26-Apr-00, to lugnet.robotics, lugnet.robotics.tele, lugnet.robotics.rcx.nqc)
 
  Re: LEGO Pneumatics (compressor application)
 
That is a great site for basic set-up, but what about a compressor application. What are the ways of establishing an electrical/mechanical means of operation? (...) (27 years ago, 26-Apr-00, to lugnet.technic, lugnet.robotics)
 
  Re: Duplex Comms with RCX
 
(...) Not that there's any pressure or anything. :) (27 years ago, 26-Apr-00, to lugnet.robotics, lugnet.robotics.tele, lugnet.robotics.rcx.nqc)
 
  Alternative Power Supplies
 
I have an RIS 1.5 set, which doesn't have the power connector. I seem to run through a set of batteries in 1-2 weeks, which will eventually get very expensive. What ways are there, other than using rechargable batteries, to supply power to the RCX (...) (27 years ago, 26-Apr-00, to lugnet.robotics.rcx)
 
  Re: Duplex Comms with RCX
 
(...) Dave had mentioned making a listen mode w/ keep-alive in a future version of nqc. But I don't think he's gotten around to that yet. (27 years ago, 26-Apr-00, to lugnet.robotics, lugnet.robotics.tele, lugnet.robotics.rcx.nqc)
 
  Re: Any other handyboard resources?
 
(...) Check out this link: (URL) haven't read through the IC manual yet, but the table of contents looks promising. Best of luck! -- Will +---...---+ | ^^ <^ ^> | | / òó ó°° \ | | / =Y= U \ | | Wendy, Will, Tatoosh & Tenzing | +---...---+ If the (...) (27 years ago, 26-Apr-00, to lugnet.robotics.handyboard)
 
  Re: Duplex Comms with RCX
 
(...) Yes. Note that it is only half-duplex. You probably expected that. (...) The biggest issue you might run into is the fact that the IR tower used by the PC times out if it doesn't transmit anything for a few seconds. Unless you have constant (...) (27 years ago, 26-Apr-00, to lugnet.robotics, lugnet.robotics.tele, lugnet.robotics.rcx.nqc)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR