To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *2086 (+5)
  Re: HB is a winner!
 
Thanks for all the congrats! We used all 16 sensor ports, and whenever we had to unhook them to fix up the robot it was a big hassle. The wires that hook up to each sensor port were fed through holes in the body of the robot. We thought of making (...) (30 years ago, 3-May-97, to lugnet.robotics.handyboard)
 
  (no subject)
 
UNSUBSCRIBE (30 years ago, 3-May-97, to lugnet.robotics.handyboard)
 
  UNSUBSCRIBE
 
UNSUBSCRIBE Thanks - john (30 years ago, 3-May-97, to lugnet.robotics.handyboard)
 
  Re: I think I blew my HB :(
 
(...) I did the something similar, with the same results. I poked around a little, but ended up buying a Tcomp (E1 based board from Ray Butts) and gluing it to the HB as a power supply. This meant using a new programming environment, but it only (...) (30 years ago, 5-May-97, to lugnet.robotics.handyboard)
 
  Re: I think I blew my HB :(
 
So you only recovered the power supply? Everthing else was bolwn up? I tested my motor chips and they appears fine so far as I can tell. I also had external circuitry with some cmos logic (inverters) and they were fine too so I imagine the latches (...) (30 years ago, 5-May-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR