To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *1536 (+5)
  Turning IR xmitter on and off
 
Hi all, I've had a few questions on this. The ir_xmit_on and ir_xmit_off routines that I use are in hb_ir.c. You could easilly write them yourself - ir_xmit_on just does poke(0x1000, 0x40) and ir_xmit_off does poke(0x1000, 0). Note that in hb_ir.c (...) (30 years ago, 25-Feb-97, to lugnet.robotics.handyboard)
 
  Umsubscribe
 
Please unsubscribe me from the mailing list. (30 years ago, 25-Feb-97, to lugnet.robotics.handyboard)
 
  use of op amp circuits with the Handy Board
 
Does anyone know how to get a negative 5 volts from the Handy board for an op amp amplifier circuit or set equations to figure out the gain of an standard op amp as the 741 or LM339 using Vee as ground and Vcc as +5 VDC? The equations only seem to (...) (30 years ago, 26-Feb-97, to lugnet.robotics.handyboard)
 
  handy board analog inputs
 
Hello, I am trying to run an assembly language program on the handy board without IC. Do the analog inputs on the handy board, marked 0-6 on the board correspond exactly to PE0-PE6 on the chip? Does the 0 input of J1 go directly to the PE0 pin? I (...) (30 years ago, 26-Feb-97, to lugnet.robotics.handyboard)
 
  Adding Functions to IC
 
Is there a way to add functions to IC? Maybe they're already somewhere that I am not aware of. I need to add ir_xmit_on and ir_xmit_off to my functions list. I know that I can poke them but I just wondered if they were already on a functions list (...) (30 years ago, 26-Feb-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR