Subject:
|
handy board analog inputs
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 26 Feb 1997 14:01:13 GMT
|
Original-From:
|
Luke <{umaskin0@cc.UManitoba.}stopspam{CA}>
|
Viewed:
|
1452 times
|
| |
|
|
Hello,
I am trying to run an assembly language program on the handy board
without IC. Do the analog inputs on the handy board, marked 0-6 on
the board correspond exactly to PE0-PE6 on the chip? Does the 0 input of
J1 go directly to the PE0 pin? I can't seem to read in a value from these
inputs. Thanks.
-Luke
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
