 | | RE: Wot no RCX power connector?
|
|
I was thinking of using only one at the end (attached to the + where it goes onto the PCB), and running a lead to clip onto the first (attached to the - ). The 4 middle ones can be ignored. Jeff jeffrey.hazen@northmill.net -----Original Message----- (...) (26 years ago, 21-Oct-99, to lugnet.robotics)
|
| |
| | RE: Wot no RCX power connector?
|
|
(...) Ummmm, you could buy 2, put one on either end of the battery compartment ann run a wire between them, right? Cheers, Ralph Hempel - P.Eng ---...--- Check out pbFORTH for LEGO Mindstorms at: (URL) ---...--- Reply to: rhempel at bmts dot com (...) (26 years ago, 21-Oct-99, to lugnet.robotics)
|
| |
| | Re: Vector 2X problem
|
|
Hi, finally my Vector2X works! Just because of the wrong selection of transistor. Guide comes from Tom Brusehaver (1997). Thanks! Any way, the result seems not consistense as the heading 'hang' when I turn off the HB and on again later. Instead of (...) (26 years ago, 21-Oct-99, to lugnet.robotics.handyboard)
|
| |
| | Pneumatics and the RCX -how?
|
|
I know that some of you use pneumatics for yuor robots. How do you do that? I suppose you use a compressor and a motor to change the valve, but that requires two motors and 2 is all that come with the MindStorms. Yes, I can buy more, but I´d like to (...) (26 years ago, 21-Oct-99, to lugnet.robotics)
|
| |
| | Re: Pneumatics and the RCX -how?
|
|
I have been searching for the answer to this one for a while. My intent is to find a supplier who has small electrically operated (solenoid) valves which can be driven by the RCX output(s). I have found one so far, but the valves are very pricy. But (...) (26 years ago, 21-Oct-99, to lugnet.robotics)
|
