 | | Re: motor drivers
|
|
David, You can replace the L293 on your MiniBoard with the TI SN754410 with no adverse effects. The two chips are pin-for-pin compatible. - Prabal (...) (30 years ago, 22-Feb-97, to lugnet.robotics.handyboard)
|
| |
 | | IR collision avoidance
|
|
Howdy, Is there anyone out there that can explain programming IC for IR collision avoidance. I have read the mobile robots book and everything in the IC manual I downloaded and the 6.270 hardware info but still haven't got a good grasp of the best (...) (30 years ago, 22-Feb-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: motor voltages
|
|
I (...) Use a couple power diodes in series with the motor power supply, _NOT_ the motor itself. You'll need pretty heafty diodes if you go this route. A typical Si diode drops between 0.6 and 0.7 volts when forward biased. String a few together and (...) (30 years ago, 23-Feb-97, to lugnet.robotics.handyboard)
|
| |
 | | motor voltages
|
|
Hello again, Thanks to all who responded to my query regarding motor chips on the Mini Board. Now that I have the more capable motor drivers installed, I want to lower the voltage that my motors see. They are getting straight 9V from the motor chips (...) (30 years ago, 23-Feb-97, to lugnet.robotics.handyboard)
|
| |
 | | Re: IR collision avoidance
|
|
(...) I'm sending this to other members of our robotics team because we JUST mastered wall-hugging IR this week. They may have other things to add. (...) Here's the pseudo code: Start Any bumpers hit? YES - Execute the back up, turn 90 degrees left (...) (30 years ago, 23-Feb-97, to lugnet.robotics.handyboard)
|