To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *14661 (+5)
  Re: equivalent darlington pair
 
Give me your address and I will send you a ZTX614. Colin (...) (27 years ago, 4-Oct-99, to lugnet.robotics.handyboard)
 
  Rcx Command Center version 3.0 available
 
Dear All, I am happy to announce that RCX Command Center version 3.0 is now available. The new version uses NQC 2.0 and is completely compatible with it (e.g. colorcoding, etc.) and contains a translator to translate NQC 1.x code to NQC 2.0. The (...) (27 years ago, 4-Oct-99, to lugnet.robotics.rcx.nqc, lugnet.robotics)
 
  Re: RCX Controlled Air Compressor Tester
 
(...) Set up a pump, a valve, and a cylinder like this. pump------Valve---...---cylnder \___...___/ Then put a few drops of oil into each tube AFTER the valve. Turn the valve so the cylinder goes up, and push the pump. Then set the valve to go down. (...) (27 years ago, 4-Oct-99, to lugnet.robotics)
 
  Lubricating Cylinders
 
(...) I've noticed that some of my cylinders are a bit "sticky" or sound like they are grinding. The small cylinders and pumps have a lubricant on them already. On a side note, I'd be careful about what kind of oil I put into these cylinders, since (...) (27 years ago, 4-Oct-99, to lugnet.robotics, lugnet.build)
 
  Re: RCX Controlled Air Compressor Tester
 
(...) Any special type of oil? I've been hesistant about using oil. As I understand it, there is rubber inside the cylinder and oil affects rubber. I'll give it a try! (27 years ago, 4-Oct-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR