To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *1466 (+5)
  Re: expansion board
 
(...) I've got a PIC chip programmed with IR collision-detection built into it (I'm trying to get some of the new 8 pin PICs to see if I can make an "all in one" unit. Basically the interface is two bits: bit 0 output - Turn on IR illumination (...) (30 years ago, 14-Feb-97, to lugnet.robotics.handyboard)
 
  Motors & handyboard
 
Yesterday I tried to run a motor out of the HB. First I tried how much current it needed with a multimeter and a 5V power source ... The result 75mA. When I tried to run the motor from the HB, after turning on the motor at low speed (motor (0,20);) (...) (30 years ago, 14-Feb-97, to lugnet.robotics.handyboard)
 
  Re: Motors & handyboard
 
(...) how did you take this measurement exactly? I think 75 mA might be kind of low, most motors will draw this much when they are just spinning but doing no useful work, but then draw much more when they are driving a geartrain. (...) actually, (...) (30 years ago, 14-Feb-97, to lugnet.robotics.handyboard)
 
  Re: expansion board
 
I used the one available IR LED driver on the HB to drive a Radio Shack high-output IR LED. This, along with a Radio Shack IR decoder module (a little silver box about the size of a sugar cube that takes +5vdc and ground, and outputs a TTL level (...) (30 years ago, 14-Feb-97, to lugnet.robotics.handyboard)
 
  Automatic feeding.
 
Has anyone worked up a system where a Hanyboard bot monitors it's battery level and then when it starts to get low it rolls over to a charging device and "plugs itself in"? It seems like this should be doable but I don't think I've seen any (...) (30 years ago, 14-Feb-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR