To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *14421 (+5)
  RE: 5VDC Voltage Regulation
 
(...) I've used 7805 voltage regulators with a faulty power supply (12v) that put out an unsteady voltage. It caused the 7805 to quickly overheat, even with a heat sink and a large capacitor across the supposed 12v and ground inputs. I really don't (...) (27 years ago, 27-Sep-99, to lugnet.robotics)
 
  RE: 5VDC Voltage Regulation
 
You need to limit the current through the relay. Just add a resistor in series with the relay. You can experiment, using a voltmeter, or you can calculate the proper value from the relay specs. Relays specs usually list the resistance of the coil. (...) (27 years ago, 27-Sep-99, to lugnet.robotics)
 
  Re: Problem with bootstrap mode
 
Hi Raj - - Trickle charge the battery for awhile (with the HB turned off), then try it again. Good luck, - Nick - (...) (27 years ago, 27-Sep-99, to lugnet.robotics.handyboard)
 
  Re: 5VDC Voltage Regulation
 
Ralph Hempel <rhempel@bmts.com> wrote in message news:000001bf0901$f5...@pro150... (...) I would just put a 33Ohm 1/2W resistor in series with the relay coil. According to the spec for the relay, the coil wants 5V at 90ma. The RCX outputs about 8V (...) (27 years ago, 27-Sep-99, to lugnet.robotics)
 
  RE: 5VDC Voltage Regulation
 
(...) Leave it to Michael to actually go through the math and put the right answer up for the group to see - nice work. Cheers, Ralph Hempel - P.Eng ---...--- Outside of a dog, a book is a man's best friend. Indside of a dog, it's too dark to (...) (27 years ago, 27-Sep-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR