To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *1406 (+5)
  Communication Problems!!!
 
i'm having problems with my handyboard communicating with my mac. i cannot seem to get either one to recognize each other in any way. when i jumper the max32 to the 25 pin connector as said in the assembly, the green LED goes on. however, i cannot (...) (30 years ago, 7-Feb-97, to lugnet.robotics.handyboard)
 
  help
 
help (30 years ago, 7-Feb-97, to lugnet.robotics.handyboard)
 
  Re: FW: expansion board schematic posted
 
(...) Hmmm... why not do this? Use a 74273 and tie it to the HB's data lines and strobe it with Y0 (or Y2 or Y4)? This would create a latched output "port" at address 0x4000. Tie two of the 74273 outputs to the 'A' side of two [N]AND gates (...) (30 years ago, 7-Feb-97, to lugnet.robotics.handyboard)
 
  RE: expansion board schematic posted
 
I've got one comment "balance". The expansion board adds 24 new inputs and only 6 new outputs. Perhaps I'm atypical but I don't need any more inputs to the handy board, I've got those aplenty, but I'm screaming for outputs to control other parts of (...) (30 years ago, 7-Feb-97, to lugnet.robotics.handyboard)
 
  shaft encoder routines
 
now available for connecting break-beam or reflective encoders to analog inputs 0 through 6. See the main page (URL) (30 years ago, 7-Feb-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR